Products
Remote Control Unit
Features:
- On/Off Security Switch or GFI On/Off Safety Switch
- 230V only
- Manual Up/Down Switch or One-touch Automatic Up/Down Switch (Auto-Stop)
- Independent Motor Leveling Switch
- (1) Three Button Hand Held Radio Transmitter
- Options: Ground Fault (requires a neutral)
Features:
- On/Off Security Switch or GFI On/Off Safety Switch (GFI shown in picture)
- Manual Up/Down Switch or One-touch automatic Up/Down Switch (Auto-Stop)
- Three Button Hand Held Radio Transmitter (remote control)
- Unit can be wired at 110 or 220V AC as long as you have a neutral
- Special Order: 220 Only (not available in GFI)
- Special Order: 50 Amps
- Special Order: Auxiliary Circuit (25$)
Remote Control Unit
Features:
- On/Off Security Switch (shown) or GFI On/Off Safety Switch
- Manual Up/Down Switch or One-touch automatic Up/Down Switch (Auto-Stop)
- Leveling Switch for Two Motor Systems
- Three Button Hand Held Radio Transmitter (remote control)
- Unit can be wired at 110 or 220V AC as long as you have a neutral
- Special Order: 220 Only (not available with GFI)
- Special Order: 50 Amps
- Special Order: Auxiliary Circuit (25$)
Auto-stop systems allow you to raise or lower your lift to a specific position at the touch of a button. Without the auto-stop functionality installed, buttons on the transmitters will have to be held down until the lift is as high or as low as you need.
Auto-stop systems require the installation of one of three “limit switches”. The limit switch you need depends on the type of motor/s that you are using. Refer to the pictures below to determine which type of limit switch you will need, and indicate this at the time of order.
|
|
UPGRADE K7004: Upgrade for a regular Gem system
UPGRADE K7004G: Upgrade for a Gem system with GFIC
- Kits K7004/K7004G allow an upgrade from the 8832 unit to a 7004 unit.
UPGRADE K7004AG: Upgrade for a Gem system with Auto-Stop and GFIC
- Kits K7004A/K7004AG allow an upgrade from the 8833 unit to a 7004A or 7004G unit.
- Kit K7004PWC includes a face card and plug, transmitter, receiver, wire harness, and wire diagram.
- Kit KAIRUPGRADE allows an upgrade from an air hose PWC to a GRP1.
Upgrade KAIR includes a PWC membrane switch, transformer, plug, transmitter, receiver, wire harness, and wire diagram.
UPGRADE KLIGHT: Allows up to 750 Watts of lighting to be switched on using the remote.